Package Include:
1 X Wireless Switch: S1PX-UK-AC230 (with UK Standards Plug & Socket)
1 X Use manual
Introduction:
This is a wireless remote switch S1PX-UK-AC230 with British standards plug and socket. You can use it to easily convert an ordinary AC power outlet into a wireless remote control switch. It can be used for remote control of lights, pumps, fans, motors, heaters, electric solenoid valves, alarms, and other AC equipment.
Key Features:
Wireless control, easy to install.
Universal input: Support 230V AC (220V~240V) used in Germany, UK, France, etc.
AC Power Output: It can control AC equipment with voltage AC 220V, 230V.
High Power: It can work at maximum current 13A.
3 Selectable Working Modes: Self-locking, Momentary, Interlocking.
Reliable Signal: RF signal can pass through walls, floors, doors, or windows, but it will lose some operating range.
Safety Features: Reverse voltage and overcurrent protection.
Interference: Two or more wireless switches may be used in the same area without interference.
Wireless Switch S1PX-UK-AC230 Parameters:
| Parameters | Detail |
|---|---|
| Input / Output Type | AC220~240V (220V/230V) |
| Plug and Socket Standards | with British Standards Plug and Socket |
| Cable Standard | three cores, 1.5 square millimeters |
| Load Capacity | 13A / channel |
| 3 Selectable Working Modes | Self-locking, Momentary, Interlocking |
| Suitable Wires for Connecting Terminals | 22-12 AWG |
| Operating Temperature | -20 °C ~ +70 °C |
| PCB Size | 90 x 59 x 18 mm (3.5 x 2.3 x 0.7 inches) |
| Case Size | 100 x 68 x 50 mm (3.9 x 2.7 x 2.0 inches) |
| Matching Transmitters |
CWB-1(50m) / C-1(100m) / CP-1(500m) / CB-1(1km) for Self-locking / Momentary CWB-2(50m) / C-2(100m) / CP-2(500m) / CB-2(1km) for Interlocking |
Setting different working modes:
The receiver will be set in Self-locking mode before leaving the factory, if you want to use another mode, please follow the following steps.
1) Setting Momentary mode: Press the wireless switch’s RF module learning button twice, signal LED flashes twice then goes off.
If you want to control an AC 230V exhaust fan with CWB-1:
Hold button → Wireless switch output AC power (exhaust fan works)
Release → Wireless switch stop outputting (exhaust fan stops)
2) Setting Self-locking mode: Press the wireless switch’s RF module learning button 3 times, signal LED flashes 3 times then goes off.
If you want to control an AC 230V exhaust fan with CWB-1:
Press once → Wireless switch output AC power (exhaust fan works)
Press again → Wireless switch stop outputting (exhaust fan stops)
3) Setting Interlocking mode: Press the wireless switch’s RF module learning button 4 times, signal LED flashes 4 times then goes off.
If you want to control an AC 230V exhaust fan with CWB-2:
Press Button A → Wireless switch output AC power (exhaust fan works)
Press Button B → Wireless switch stop outputting (exhaust fan stops)